Aug 20, 2022 PASS Cisco 100-101 EXAM WITH UPDATED DUMPS
100-101 Questions PDF [2022] Use Valid New dump to Clear Exam
Cisco 100-101 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
NEW QUESTION 37
Refer to the exhibit.
All devices attached to the network are shown. How many collision domains are present in this network?
- A. 0
- B. 1
- C. 2
- D. 3
- E. 4
Answer: D
Explanation:
A switch uses a separate collision domain for each port so there are a total of 9 for each device shown. In addition to this, the switch to switch connections (3) are a separate collision domain. Finally, we add the switch to router connections (2) and the router to router connection (1) for a total of 15.
NEW QUESTION 38
Refer to the exhibit.
The exhibit is showing the topology and the MAC address table. Host A sends a data frame to host D.
What will the switch do when it receives the frame from host A?
- A. The switch will flood the frame out of all ports except for port Fa0/3.
- B. The switch will add the source address and port to the MAC address table and forward the frame to host D.
- C. The switch will discard the frame and send an error message back to host A.
- D. The switch will add the destination address of the frame to the MAC address table and forward the frame to host
Answer: B
Explanation:
When switch receives the data frame from the host not having the MAC address already on the MAC table, it will add the MAC address to source port on MAC address table and sends the data frame.
NEW QUESTION 39
OSPF is configured using default classful addressing. With all routers and interfaces operational, how many networks will be in the routing table of R1 that are indicated to be learned by OSPF?
- A. 0
- B. 1
- C. 2
- D. 3
- E. 4
- F. 5
Answer: F
NEW QUESTION 40
Refer to the exhibit.
The enterprise has decided to use the network address 172.16.0.0. The network administrator needs to design a classful addressing scheme to accommodate the three subnets, with 30, 40, and 50 hosts, as shown. What subnet mask would accommodate this network?
- A. 255.255.255.252
- B. 255.255.255.240
- C. 255.255.255.224
- D. 255.255.255.248
- E. 255.255.255.192
Answer: E
Explanation:
Subnet mask A i.e. 255.255.255.192 with CIDR of /26 which means 64 hosts per subnet which are sufficient to accommodate even the largest subnet of 50 hosts.
NEW QUESTION 41
The network administrator is using a Windows PC application that is called putty.exe for remote communication to a switch for network troubleshooting. Which two protocols could be used during this communication? (Choose two.)
- A. Telnet
- B. SSH
- C. SNMP
- D. HTTP
- E. RMON
Answer: A,B
NEW QUESTION 42
When you begin a new campaign on Ads Manager, what is the first step in the process?
- A. Select where ads will be seen through placements
- B. Create a Lookalike Audience based on website visitors
- C. Produce the right creative for the campaign
- D. Align your marketing goal with a campaign objective
Answer: D
NEW QUESTION 43
What are two common TCP applications? (Choose two.)
- A. FTP
- B. SMTP
- C. TFTP
- D. DNS
- E. SNMP
Answer: A,B
Explanation:
SMTP uses TCP port 25, while FTP uses TCP ports 20 and 21. http://pentestlab.wordpress.com/2012/03/05/common-tcpip-ports/
NEW QUESTION 44
Refer to the exhibit.
A problem with network connectivity has been observed. It is suspected that the cable connected to switch port
Fa0/9 on Switch1 is disconnected. What would be an effect of this cable being disconnected?
- A. The transfer of files from Host B to the server in VLAN9 would be significantly slower.
- B. For less than a minute, Host B would not be able to access the server in VLAN9. Then normal network function would resume.
- C. Communication between VLAN3 and the other VLANs would be disabled.
- D. Host B would not be able to access the server in VLAN9 until the cable is reconnected.
Answer: B
NEW QUESTION 45
What is a valid reason that an ad would be rejected by Facebook?
- A. The ad contained sexually suggestive images.
- B. The link to the landing pages included content that was relevant to the ad
- C. An image within the ad was relevant to its message
- D. Lead ads were used to receive email, first name and phone number
Answer: A
NEW QUESTION 46
If a host experiences intermittent issues that relate to congestion within a network while remaining connected, what could cause congestion on this LAN?
- A. broadcast storms
- B. half-duplex operation
- C. multicasting
- D. network segmentation
Answer: A
Explanation:
Explanation/Reference:
A broadcast storm can consume sufficient network resources so as to render the network
unable to transport normal traffic.
NEW QUESTION 47
After years of advertising on TV, a branding advertiser wants to start running ads on the Facebook App. The advertiser has a TV ad with an emotional message to connect the brand with customers The TV ad lasts 30 seconds.
What is the best creative approach to run this campaign?
- A. Create a 15-second video ad with the content used on TV
- B. Create a 20 second video ad with a shorter version of the content used on TV
- C. Create a 15-second video ad that is vertical with the content used on TV
- D. Create a video ad with the content used on TV
Answer: A
NEW QUESTION 48
What is a benefit of using the Meta pixel?
- A. To decrease ad creation time
- B. To improve the ability to download reports
- C. To decrease ad approval time
- D. To optimize campaign delivery
Answer: A
NEW QUESTION 49
CORRECT TEXT
There are three locations in a school district of a large city: ROUTER -M, ROUTER -W and ROUTER -U. The network connection between two of these locations has already functioned. Configure the ROUTER -M router IP addresses on the E0 and S0 interfaces so that the E0 receives the first usable subnet while the S0 receives the second usable subnet from the network 192.168.160.0/28. Both interfaces would receive the last available ip address on the proper subnet.
Note: The OSPF process must be configured to allow interfaces in specific subnets to participate in the routing process.
Answer:
Explanation:
ROUTER-M> enable
Password: Cisco
ROUTER-M# config t
ROUTER-M(config)# interface e0
ROUTER-M(config-if)# ip address 192.168.160.14 255.255.255.240
ROUTER-M(config-if)# no shutdown
ROUTER -M(config-if)# exit
ROUTER -M(config)# interface s0
ROUTER-M(config-if)# ip address 192.168.160.30 255.255.255.240
ROUTER-M(config-if)# no shutdown
ROUTER-M(config-if)# end
ROUTER-M# copy run start
NEW QUESTION 50
Scenario
Refer to the topology. Your company has decided to connect the main office with three other remote branch offices using point-to-point serial links.
You are required to troubleshoot and resolve OSPF neighbor adjacency issues between the main office and the routers located in the remote branch offices.
R1 does not form an OSPF neighbor adjacency with R2. Which option would fix the issue?
- A. R1 ethernetO/1 is shutdown. Configure no shutdown command.
- B. R1 ethernetO/1 configured with a non-default OSPF hello interval of 25: configure no ip ospf hello-interval 25
- C. R2 ethernetO/1 and R3 ethernetO/O are configured with a non-default OSPF hello interval of 25; configure no ip ospf hello-interval 25
- D. Enable OSPF for R1 ethernetO/1; configure ip ospf 1 area 0 command under ethernetO/1
Answer: B
Explanation:
Looking at the configuration of R1, we see that R1 is configured with a hello interval of 25 on interface Ethernet 0/1 while R2 is left with the default of 10 (not configured).
NEW QUESTION 51
Which option is best to reach existing customers?
- A. Conversion audience
- B. Lookalike Audience
- C. Custom Audience
- D. Interest-based audience
Answer: C
NEW QUESTION 52
Which two statements describe the process identifier that is used in the command to configure OSPF on a router? (Choose two.)
Router(config)# router ospf 1
- A. Hello packets are sent to each neighbor to determine the processor identifier.
- B. All OSPF routers in an area must have the same process ID.
- C. The process number can be any number from 1 to 65,535.
- D. Different process identifiers can be used to run multiple OSPF processes
- E. Only one process number can be used on the same router.
Answer: C,D
Explanation:
Explanation/Reference:
Multiple OSPF processes can be configured on a router using multiple process ID's.
The valid process ID's are shown below:
Edge-B(config)#router ospf <1-65535> Process ID
NEW QUESTION 53
Refer to the graphic.
R1 is unable to establish an OSPF neighbor relationship with R3. What are possible reasons for this problem? (Choose two.)
- A. All of the routers need to be configured for backbone Area 1.
- B. R1 and R3 are configured in different areas.
- C. EIGRP is also configured on these routers with a lower administrative distance.
- D. The hello and dead interval timers are not set to the same values on R1 and R3.
- E. R1 and R2 are the DR and BDR, so OSPF will not establish neighbor adjacency with R3.
- F. A static route has been configured from R1 to R3 and prevents the neighbor adjacency from being established.
Answer: B,D
Explanation:
This question is to examine the conditions for OSPF to create neighborhood.
So as to make the two routers become neighbors, each router must be matched with the
following items:
1.The area ID and its types;
2.Hello and failure time interval timer;
3.OSPF Password (Optional);
NEW QUESTION 54
Which statement about IPv6 is true?
- A. Broadcasts have been eliminated and replaced with multicasts.
- B. There are 2.7 billion addresses available.
- C. Addresses are not hierarchical and are assigned at random.
- D. Only one IPv6 address can exist on a given interface.
Answer: A
Explanation:
Explanation/Reference:
http://technet.microsoft.com/en-us/library/cc757359(v=ws.10).aspx
IPv6 has three types of addresses, which can be categorized by type and scope:
Unicast addresses. A packet is delivered to one interface.
Multicast addresses. A packet is delivered to multiple interfaces.
Anycast addresses. A packet is delivered to the nearest of multiple interfaces (in terms of
routing distance).
IPv6 does not use broadcast messages.
Unicast and anycast addresses in IPv6 have the following scopes (for multicast addresses,
the scope are built into the address structure):
Link-local. The scope is the local link (nodes on the same subnet).
Site-local. The scope is the organization (private site addressing).
Global. The scope is global (IPv6 Internet addresses).
In addition, IPv6 has special addresses such as the loopback address. The scope of a
special address depends on the type of special address.
Much of the IPv6 address space is unassigned.
NEW QUESTION 55
......
100-101 Study Guide Brilliant 100-101 Exam Dumps PDF: https://www.prep4sureexam.com/100-101-dumps-torrent.html
Passing Cisco 100-101 Exam Using 2022 Practice Tests: https://drive.google.com/open?id=1qyk8q9M36BpRPUQswiNVai-oOY76b_UT